Huddlecamhd 3X Manuel d'utilisateur

Ver 1.1 6/30/14 OSD MENU……………………………………………………………………………………………..

Ver 1.1 6/30/14 The Lens OSD Menu is as follows: (not applicable, see note above) • DISPLAY Default Value: Off On Screen Display = On or

Ver 1.1 6/30/14 IR Remote Controller (Note: Some buttons do not operate for all camera models)

Ver 1.1 6/30/14 11. Pan/Tilt Function Zone L-Limit: Set left boundary limit scanning position Scan: Enable Boundary Scanning (Auto Panning)

Ver 1.1 6/30/14 Installation Instructions……………………………………………………………………… Desktop Installation……………………………………………………………………………… When using the HuddleCam

Ver 1.1 6/30/14 To fix the tripod mount to the bottom of the camera, use the supplied screws to hold it in place. Then screw

Ver 1.1 6/30/14 Wall and Ceiling Mount…………………………………………………………………………

Ver 1.1 6/30/14 Troubleshooting………….………………………………………………………………………… Problem Cause Resolution There is no power to the camera. Power adapter is

Ver 1.1 6/30/14 Precautions………………………………………………………………………………………….

Ver 1.1 6/30/14 • IR Remote Controller • Control Cable (1) • User Manual (1) Rear Board Connectors…………………………………………………………………………

Ver 1.1 6/30/14 1. Front View……………………………………………………………………………………. 1. Lens 10x Optical Zoom. 2. IR Receiver To receive IR remote controller signa

Ver 1.1 6/30/14 2. Rear View…………………………………………………………………………………… 5. DC

Ver 1.1 6/30/14 3. Bottom View………………………………………………………………………………… 1. Tripod

Ver 1.1 6/30/14 4. Dip-Switch Settings…………………………………………………………………………… Note: When changing Dip-Switch settings, make all changes with camera powered

Ver 1.1 6/30/14 code can control the dome camera. SW2: Used for communication settings. SW2 DIP-1,2,3: Baud Rate, Communication Protocol SW2 DIP

Ver 1.1 6/30/14 Cable Connection Info………………………………………………………………………… VISCA RS-23